I have a 2007 Jeep Grand Cherokee and the Evo-All CHRT 5 starter worked when I first installed it a couple months back. I performed a hard reset because i thought i programed something wrong due to the security light blinking during remote start and now it wont work.It goes through the programing sequence with no issues. During remote start it works properly unitl it wants to start. I put my meter on the yellow with red wire located on the red plug and there isnt 12 volts when attempting to start. Is this a programing issue or do I have a faulty module? To entertain the idea, i double checked all my connections and everything tests ok on that end. The only smoking gun i can seem to find is that their isnt 12 volts at that yellow with red wire during remote start. I continued to jumper 12 volts to that wire during the remote start sequence and the engine will crank over but not run. It will continue to crank until i remove that wire. Also, if i insert the key during the remote start process and turn it to the on position (without cranking it over) the remote start will work. Hopefully you can shed some light on the situation. Thank you for your time.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
